SparkFun Accessories Heat Sink Compound

SparkFun Accessories Stackable Header 2x23 Pin Female

SparkFun Accessories These stackable headers are made to work with the SparkFun ESP32 Thing Plus to connect to shield with a Feather footprint. This set includes one 12-pin and one 16-pin header; the pins are spaced by 0.1".Each set of headers allows you to stack Feather

SparkFun Accessories 2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4" long. Not sure which RF connector you need on your antenna? Check out our RF Connector Guide

SparkFun Accessories 900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long. Be sure to pick the antenna with the right connector. Almost all 2.4GHz and 915MHz antennas need to be RP-SMA.

SparkFun Accessories This cute little coax is a champ in our RF kit! It has a right angle female U.FL (aka I-PEX) connector on both ends. Now instead of jerry-rigging a few U.FL to SMA cables together we can go straight from one U.FL device to another. As an added bonus

SparkFun Accessories Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.This is a 15ft. length of 10-wire ribbon cable. Check th

SparkFun Accessories These are your standard issue USB 2.0 type A to micro USB 5-pin... but wait what's this? These cables have minor yet genius modifications that allow both ends to be plugged into their ports regardless of their orientation. No longer will you fight

SparkFun Accessories An adjustable potentiometer can open up many interesting user interfaces. Turn the pot and the resistance changes. Connect VCC to an outer pin GND to the other and the center pin will have a voltage that varies from 0 to VCC depending on the rotati

SparkFun Accessories This is a coin cell holder for the common CR2032 type battery. The holder has a neat pop-in pop-out feature that makes changing the battery easy. The feet of the holder have a small hole that allow it to be sewn without modification.

SparkFun Accessories This is 30 feet of conductive thread spun from stainless steel fiber and wound on a plastic bobbin. Use it to sew up all of your e-textile projects. This small bobbin is a great way to get into wearable electronics without the upfront cost of buying

SparkFun Accessories Dip sockets for all your prototyping needs. If you've ever had to de-solder a dip part from a circuit board you know how valuable these are! Number of pins include: 8 14 16 18 28 and 40.This is a 300mil wide 8-pin socket.